DAB EVOPLUS SMALL 110/180 SAN M – electronic circulation pump for hot water, bronze body, 1 1/2"

Product detailed description

The pump EVOPLUS SMALL 110/180 SAN M (code 60151147) is the SAN version of the DAB EVOPLUS SMALL range. It differs from standard models by its bronze body, which allows the manufacturer to specify it for potable water – typically for the circulation loop of hot domestic water. The electronics continuously monitor changes in hydraulic conditions in the system and adjust the motor speed accordingly to ensure circulation with the lowest possible energy consumption.

Model parameters

• max. head 11.0 m, max. flow 9.0 m³/h
• max. power P1 170 W, power supply 1 × 220–240 V, 50/60 Hz
• threaded connection 1 1/2" on the body, flange (standard 1" with internal thread) according to the technical sheet on order
• mounting length 180 mm, weight 2.8 kg

Control and regulation

It is factory-set to proportional differential pressure (ΔP-v), at which the manufacturer states the best energy efficiency index. Constant differential pressure (ΔP-c) and constant curve mode with fixed speed are also available. For the SAN version, the manufacturer describes the constant temperature mode, which maintains the desired water temperature in the circulation pipe without thermostatic valves. The settings are made on an OLED display with four navigation buttons; remote control (0–10 V, PWM, 4–20 mA, ModBus) is enabled by optional expansion modules.

Operating conditions

• liquid temperature −10 to +110 °C, ambient temperature max. +40 °C
• max. operating pressure 16 bar
• protection class IP44, insulation class F
• clean liquid without solid particles and mineral oils

The pump is mounted with the motor shaft in a horizontal position. The motor is protected against overload, overheating, overvoltage and undervoltage, so no external motor protection is required. Electrical wiring and grounding must be done by a qualified technician.

Technical parameters

Frequently asked questions

Is the EVOPLUS SMALL 110/180 SAN M pump suitable for potable water?
Yes. The SAN version has a bronze body and, according to the manual, is intended for potable water, for example for the circulation of hot domestic water. Cast iron models of EVOPLUS without the SAN designation are not intended for domestic water.

Is the flange part of the delivery?
The technical sheet lists the flange as an optional accessory, standard with internal thread 1". The pump itself has a 1 1/2" thread on the body and a mounting length of 180 mm.

How should the pump be installed correctly?
The motor shaft must be horizontal and the electronics in a vertical position. The direction of flow is indicated by an arrow on the body; closing valves are recommended on the suction and discharge sides to facilitate inspection and maintenance.