HAKL TF 150/ 1.5 m² grid

Product detailed description

BASIC PROPERTIES

• intended for wet installation by embedding into adhesive mortar
• ideal for renovations thanks to the small cable thickness of only 3 mm
• suitable for ceramic tiles, vinyl adhesive parquet and others
• self-adhesive fixing tapes on the bottom side of the mat
• protective braiding of the cable allows installation in humid areas
• can also be used as the main heat source in a room
• low-maintenance operation, no need for regular service
• high-quality heating elements with a melting point up to 1100 °C
• each product is subjected to strict quality control testing

PRODUCT DESCRIPTION

The electric floor heating mats HAKL TF 150 have a power of 150 W per square meter and a standard width of 0.5 m. They are connected to the electrical grid using two connecting cables with a length of 3 meters. In order to achieve the most efficient operation, it is recommended to install a thermostat HAKL TH with a floor sensor in each room. Energy savings and thus cost savings can also be achieved by choosing the right type of flooring and sufficient thermal insulation under the floor heating. Thanks to its low-maintenance operation, the HAKL floor heating meets even the most demanding requirements for quality and comfort.
Before installation, the manufacturer recommends reading the installation instructions carefully, where you will find a detailed description of the product and its wiring.

Illustration of the connection of the HAKL TF floor heating using two connecting cables.

FLOOR COMPOSITION

The heating mats HAKL TF 150 are intended for wet installation by embedding into adhesive mortar directly under the floor covering. With this type of floor composition, so-called "DIRECT HEATING" is achieved. The heating mat is placed between the floor covering and the thermal insulation, which causes rapid heating. Therefore, they are recommended to be laid, for example, in temporarily used rooms or during renovations where there is not enough space to increase the floor height.

 Illustration of the floor composition:
1. floor covering - tiles, 2. flexible adhesive mortar, 3. HAKL TF heating mat, 4. HAKL TB insulation, 5. adhesive glue, 6. concrete base  

HEATING CABLE

The heating cables HAKL TF feature high-quality heating elements - the resistance wire comes from the renowned Swedish manufacturer KANTHAL. The cable sheath is made of highly heat-resistant material with an overall cable thickness of 3 mm, which does not deform even during prolonged heating. When connecting the floor heating without a thermostat, the heating cable heats up to a maximum of 65°C, while the melting point is as high as 1100 °C.
The heating cables themselves are protected by a dense metal protective braiding, which increases their durability and allows installation in humid areas (bathroom, WC…)

Illustration of a cross-section of the heating cable.

QUALITY CERTIFICATE

Each individual heating mat is subjected to an output load test, during which connections are tested, insulation breakdown is measured, total cable resistance is measured, etc.
This record of individual tests is included in the Quality Certificate. The product must meet all parameters 100% in order to leave the production line.

Illustration.

TABLE OF SUITABILITY FOR USE