PEX/PEX/PEX 32x32x32 mm Compression T-Junction for PEX-AL-PEX Pipe

Product detailed description

The compression T-piece 32 × 32 × 32 mm is used to create a branch in the distribution from multilayer PEX-AL-PEX pipe with an outer diameter of 32 mm. All three outlets have the same dimensions, so you can divide the main branch into two directions without changing the diameter – for example, when connecting a bathroom, kitchen or utility room from one distribution branch.

The body is made of nickel-plated brass, which is resistant to corrosion and easy to install. The fitting is joined by compression – after compression, the joint is strong and permanently sealed, without the need for sealing tape or further sealing. The compression rings have inspection holes, through which you can check during installation that the pipe is fully inserted. The fitting is covered by a 10-year manufacturer's warranty.

Installation and use

Cut the pipe perpendicularly, remove the burr and calibrate the end using the appropriate tools. Then insert it into the fitting collar until it reaches the stop and check its position through the inspection hole. Compress the joint using compression pliers or a crimper with U-profile jaws for the size 32 mm. The compressed joint is non-releasable, so before compression, check the direction of the branch and the position of the fitting.

A hygiene certificate from the State Health Institute (PZH) has been issued for the use of brass fittings in the PEX-AL-PEX system in drinking water installations. A copy of the certificate can be found in the related files with the product. Before putting the installation into operation, flush it with water in such a volume that the water in it is completely replaced.

Most frequently asked questions

For which pipe is the T-piece intended?
For multilayer PEX-AL-PEX pipe with a diameter of 32 mm. All three outlets of the T-piece have the same dimension of 32 mm.

What tools do I need for installation?
Compression pliers or a crimper with U-profile jaws for the size 32 mm and tools for calibration and deburring the pipe end.

Is the fitting suitable for drinking water systems?
Yes. A hygiene certificate from PZH has been issued for the use of brass fittings in the PEX-AL-PEX system in drinking water installations (valid until 26. 3. 2029). A copy of the certificate can be found in the related files.

Can the compressed joint be disassembled later?
No, the compressed joint is non-releasable. In the case of a change in the distribution, the fitting is replaced with a new one.

What is the warranty?
The manufacturer provides a 10-year warranty on the fitting.

Technical parameters