T-piece 90° PRESS GAS - equal - 54mm
Code: IVNGAS40.54Related products
Product detailed description
T-piece 90° PRESS GAS - reducing - 54mm
- PN 5, T = -20 °C to +70 °C
- T-piece 90° reducing PRESS x PRESS x PRESS
- intended use: for natural gas, biogas and propane distribution systems in gaseous phase
- material: stainless steel Wst. Nr. 1.4404 (AISI 316L), yellow HNBR sealing O-ring
- SZÚ Brno, DVGW certification
Note: Dimensions of PRESS GAS fittings 76.1, 88.9 and 108 mm available on request.
Frequently Asked Questions
- What tools do I need to install this fitting? Press fittings require specialized pressing tongs with the correct jaw type (commonly labeled B, F, or TH depending on the system) matching the size and type of the fitting - without the proper tool, the joint cannot be made or checked.
- How do I know the joint has been pressed correctly? Quality press fittings have a press indicator (e.g. a sealing O-ring that leaks if pressing is incomplete) - a pressure test of the entire system should always be carried out before the joint is embedded in a wall or screed.
- Can the joint be disassembled after pressing? No, unlike a screwed (compression) connection, a pressed joint is permanent and removing it requires cutting out the fitting and replacing it with a new one.
- Must the installation be carried out by a professional? Yes, pressing fittings requires professional skill and correctly calibrated tools - we recommend leaving this to a heating engineer/plumber, especially for joints that will be embedded in a wall or screed without the possibility of later inspection.
Additional parameters
| Category: | IVAR.IVN40 GAS - T-pieces 90° PRESS GAS |
|---|---|
| Material type: | stainless steel Wst. Nr. 1.4404 (AISI 316L), yellow HNBR sealing O-ring |
| Operating temperature: | -20 °C |
| Nominal pressure: | PN 5 |
| Last price update:: | 13.04.2026 1:03:24 |
Product rating
Be the first who will post an article to this item!
Discussion
List of discussions
R
Rastislav
Rastislav
Chcem použiť tento T-kus na rozvod plynu v kotolni, kde sa vetva oddeľuje pod uhlom 90° – je to ten správny kus, alebo potrebujem niečo iné, keď chcem, aby hlavná vetva pokračovala rovno a odbočka išla do strany?
A
ATRIA.SK
ATRIA.SK
Áno, presne na to je tento T-kus určený – hlavná trasa pokračuje rovno a odbočka ide kolmo do strany, takže pre váš prípad je to správna voľba. Je to press spojka pre plyn, takže montáž prebieha lisovaním bez závitov či spájkovania. Len nezabudnite, že na lisovanie press fitingov pre plyn potrebujete lisovací nástroj s čeľusťami vhodného profilu pre plynové fittingy.