High-flow cyclonic dirt separator IVAR.DEPURA CYCLON NW 800 – flanges DN 80, 32 m³/h, insert 25 µm

Product detailed description

The model NW 800 with code 1602010003 is a flanged filter for mechanical impurities designed for large water flows – an average of 32 m³/h at a pressure loss of 0.2 bar. Water in the filter head first passes through a centrifugal pre-filtration with a cyclone effect and then through a nylon insert with a porosity of 25 µm and a filtration area of 1288 cm². The trapped sand, silt or rust is flushed out by water into the drain after opening the blow-down valve. The filter is manufactured by the Belgian company AIRWATEC (brand CINTROPUR) and the materials used are suitable for drinking water and the food industry.

Where is it used

In industry, it protects sanitary fittings and machining tools; in agriculture, it filters water for irrigation and animal feeding, rainwater and water from wells and reservoirs. In residential and commercial buildings – hotels, restaurants, schools or apartment buildings – it protects household piping and sanitary installations.

Packaging and accessories

• 2 flanged ends DN 80 according to DIN EN 1092-1 PN 10 with openings according to PN 16, fastening 8 × M16
• 2 glycerine-filled pressure gauges 0–20 bar (thread 1/4") for monitoring the clogging of the insert
• installed insert 25 µm, air vent and key for disassembling the container
• optionally a stainless steel wall bracket (1802030018), black container and flat gaskets

Installation and maintenance

The filter is installed on the water inlet after the water meter or after the pump, with a bypass and shut-off valves; never on the suction side of the pump. The piping must not carry the weight of the filter (7.4 kg). Flanges are connected to the head with a metric thread M88 × 2.8, so it is necessary to use the original supplied parts; their bolts are tightened only slightly – 30 Nm for flat gaskets and 15 Nm for profiled gaskets. At pressures above 10 bar, a pressure-reducing valve must be installed before the filter; in a system without an expansion tank, a balancing pressure tank with a volume of at least 2 l is required. The insert must be cleaned or replaced when the pressure difference is 2 bar, but at least three times a year; inserts of 25, 50 and 100 µm are single-use, nylon inserts of 150 and 300 µm can be cleaned. Spare inserts are supplied in sets of 5 pcs (25 µm: 1702045752). It is advisable to disinfect drinking water systems after installation.

Technical parameters

Frequently asked questions

When should the filtration insert be cleaned or replaced?
When the pressure difference on the pressure gauges reaches 2 bar, but no later than three times a year. Inserts of 25, 50 and 100 µm are single-use, inserts of 150 and 300 µm can be cleaned and reused.

What is included in the packaging?
Two flanged ends DN 80, two pressure gauges, an installed insert of 25 µm, an air vent and a key for disassembling the container. A stainless steel wall bracket is optional.

What bolts and gaskets do I need for the NW 800 flanges?
The flange is fastened with 8 bolts M16 and sealed with a flat EPDM gasket PN 10 or PN 16. The bolts are tightened to 30 Nm for flat gaskets and to 15 Nm for profiled gaskets.

Can I install the filter on the pump suction side?
No, the filter must not be installed on the suction side of the pump or in places where a vacuum occurs in the water supply. It is always installed with a bypass and shut-off valves.